PROCEDURE
DISCHARGE FUEL SYSTEM PRESSURE
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE SEPARATE TYPE REAR SEAT CUSHION ASSEMBLY LH
REMOVE SEPARATE TYPE REAR SEAT CUSHION ASSEMBLY RH
REMOVE NO. 2 REAR FLOOR SERVICE HOLE COVER
REMOVE FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE
REMOVE FUEL SENDER GAUGE ASSEMBLY
Disconnect the fuel sender gauge assembly connector.
Disconnect the fuel pump harness from the 2 clamps.
Disconnect the fuel pump harness from the clamp.
Push the claw labeled A of the fuel sender gauge assembly, and then pull up the fuel sender gauge assembly to remove it.
Note
Be careful not to bend the arm of the fuel sender gauge assembly.
Push | |
Pull up |
REMOVE REAR FLOOR SERVICE HOLE COVER
Remove the rear floor service hole cover.
Disconnect the fuel tank return tube connector.
REMOVE FUEL TANK RETURN TUBE
Temporarily install SST to the fuel pump gauge retainer.
Note
Do not apply a claw of SST at the marked part.
*a | Marked Part |
Tech Tips
Be sure to use SST (claws) as shown in the illustration.
Engage SST (claws) securely with the fuel pump gauge retainer ribs to secure SST.
While securely pressing SST (claws) against the fuel pump gauge retainer ribs, tighten the 4 bolts.
Install SST (handle).
Lightly press down on SST to prevent it from separating from the fuel pump gauge retainer. While pressing SST, rotate the handle slowly to loosen the fuel pump gauge retainer.
Note
Do not use any tools other than those specified in this operation. Damage to the fuel pump gauge retainer or fuel tank may result.
Do not press down on SST excessively as this may make the fuel pump gauge retainer hard to rotate and may damage components.
Make sure to rotate SST (handle) horizontally. If SST (handle) is rotated at an angle, SST may come off.
Do not spin SST too fast or use an impact wrench as this may result in damage to components.
If SST comes off of the fuel pump gauge retainer, loosen SST (bolts) and reinstall SST.
Remove the fuel pump gauge retainer.
Disengage the clamp and separate the fuel tank vent hose sub-assembly from the fuel tank return tube.
Remove the fuel tank return tube from the fuel tank assembly.
Note
Be careful not to bend the arm of the No. 2 fuel sender gauge assembly.
Remove the gasket from the fuel tank assembly.
REMOVE NO. 2 FUEL SENDER GAUGE ASSEMBLY
Disconnect the No. 2 fuel sender gauge assembly connector.
Disconnect the fuel pump harness from the clamp.
Push the claw labeled A of the No. 2 fuel sender gauge assembly, and then pull up the No. 2 fuel sender gauge assembly to remove it.
Push | |
Pull up |