CAUTION / NOTICE / HINT
Tech Tips
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
PROCEDURE
PRECAUTION
CAUTION:
Be sure to read Precaution thoroughly before servicing Click here.
Note
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.
REMOVE REAR NO. 2 FLOOR BOARD
REMOVE REAR DECK FLOOR BOX
REMOVE REAR NO. 3 FLOOR BOARD
REMOVE DECK FLOOR BOX RH
REMOVE REAR FLOOR BOARD UPPER NO. 3 PLATE
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE FRONT BUMPER ASSEMBLY
REMOVE FRONT FENDER SIDE PANEL PROTECTOR
REMOVE HEADLIGHT ASSEMBLY
for Halogen Headlight: Click here
for LED Headlight: Click here
REMOVE FRONT AIRBAG SENSOR
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Disconnect the connector from the front airbag sensor.
Note
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Push down the white housing lock and slide the yellow CPA. (At this time, the connector cannot be disconnected yet.)
*1 | Housing Lock | *2 | CPA |
*a | Connector Lock is Released | - | - |
Push down the white housing lock again and disconnect the connector.
Note
Do not push down the part (A) shown in the illustration when disconnecting.
After disconnecting the connector, check that the position of the white housing lock is correct as shown in the illustration.
Remove the bolt and front airbag sensor.
Note
Loosen the bolt while holding the front airbag sensor because the front airbag sensor pin (stopper) is easily damaged.