After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.
REMOVE REAR NO. 2 FLOOR BOARD
REMOVE REAR DECK FLOOR BOX
REMOVE REAR NO. 3 FLOOR BOARD
REMOVE DECK FLOOR BOX RH
REMOVE REAR FLOOR BOARD UPPER NO. 3 PLATE
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
Use the same procedure for the RH and LH side Click here.
REMOVE INSTRUMENT SIDE PANEL
REMOVE NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH (for Metal Finish Panel and Urethane Panel)
REMOVE NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH (for Wood Panel and Bamboo Panel)
REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL
REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH
REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH
REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY
REMOVE AIR CONDITIONING CONTROL ASSEMBLY
REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET
Remove the 4 bolts.
Pull the radio receiver assembly with bracket toward the rear of the vehicle.
Disconnect each connector and remove the radio receiver assembly with bracket.
REMOVE DOUBLE LOCK DOOR CONTROL RELAY ASSEMBLY (w/ Double Locking System)
REMOVE NO. 1 RADIO BRACKET
Remove the 4 screws and No. 1 radio bracket.
REMOVE NO. 2 RADIO BRACKET
Remove the 4 screws and No. 2 radio bracket.
REMOVE RADIO RECEIVER ASSEMBLY (w/o Multi-display)
REMOVE RADIO RECEIVER ASSEMBLY (w/ Multi-display)