CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front seat outer belt assembly removal/installation are shown below.
Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
---|---|---|---|
Disconnect cable from negative auxiliary battery terminal | Memorize steering angle neutral point | Lane departure alert system (w/ Steering Control) | |
Intelligent clearance sonar system*1 | |||
Simple intelligent parking assist system*1 | |||
Pre-crash safety system | |||
Parking assist monitor system | |||
Initialize back door lock | Power door lock control system |
*1: When performing learning using the GTS.
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Wear protective gloves. Sharp areas on the parts may injure your hands.
Tech Tips
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
PRECAUTION
Note
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If an SRS part is accidentally deployed, it may cause a serious injury.
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
REMOVE FRONT DOOR SCUFF PLATE
DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
Disconnect the front door opening trim weatherstrip.
REMOVE REAR DOOR SCUFF PLATE
DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
Disconnect the rear door opening trim weatherstrip.
REMOVE LAP BELT OUTER ANCHOR COVER
Disengage the 3 claws to remove the lap belt outer anchor cover.
DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY
Remove the bolt to disconnect the floor anchor of the front seat outer belt assembly.
REMOVE LOWER CENTER PILLAR GARNISH
REMOVE CENTER PILLAR GARNISH ASSEMBLY
REMOVE FRONT SEAT OUTER BELT ASSEMBLY
Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.
*a | Protective Tape |
*b | Locking Button |
*c | Release |
Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the pretensioner connector.
Tech Tips
Tape the screwdriver tip before use.
Remove the 2 bolts.
Disengage the 2 guides to remove the front seat outer belt assembly.
REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
Remove the 2 bolts.
Disengage the guide to remove the front shoulder belt anchor adjuster assembly.