POWER WINDOW REGULATOR MOTOR(for Rear Door) REMOVAL
CAUTION / NOTICE / HINT
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
PRECAUTION
Note:After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Note:When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
REMOVE REAR DOOR INSIDE HANDLE BEZEL LH
REMOVE REAR DOOR TRIM MOULDING LH
REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY LH
REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH
REMOVE REAR DOOR SERVICE HOLE COVER LH
REMOVE REAR DOOR GLASS RUN LH
REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
REMOVE REAR DOOR QUARTER WINDOW GLASS LH
REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY LH
-
Disconnect the connector.
Table 1. Text in Illustration *1
Temporary Bolt
Loosen the temporary bolt.
Note:Do not remove the temporary bolt. If the temporary bolt is removed, the rear door window regulator may fall and cause damage.
Remove the 3 bolts.
Remove the rear door window regulator assembly.
Remove the temporary bolt from the rear door window regulator.
-