RADIO RECEIVER REMOVAL

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (Click here).

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH

  4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH

  5. REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY

  6. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type)

    1. E269299

      Remove the 4 screws.

    2. E269300

      Pull the radio receiver assembly with bracket to detach the 4 clips on the backside of the radio receiver assembly with bracket.

    3. Disconnect the connectors and remove the radio receiver assembly with bracket.

  7. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display Type)

    1. E345095

      Remove the 4 screws.

    2. E345096

      Pull the radio receiver and display receiver assembly with bracket to detach the 4 clips on the backside of the radio and display receiver assembly with bracket.

    3. Disconnect the connectors and remove the radio and display receiver assembly with bracket.

  8. REMOVE NO. 1 RADIO BRACKET (for Radio Receiver Type)

    1. E269303

      Remove the 3 screws and No. 1 radio bracket.

  9. REMOVE NO. 1 RADIO BRACKET (for Radio and Display Type)

    1. E345097

      Remove the 3 screws and No. 1 radio bracket.

  10. REMOVE NO. 2 RADIO BRACKET (for Radio Receiver Type)

    1. E269305

      Remove the 3 screws and No. 2 radio bracket.

  11. REMOVE NO. 2 RADIO BRACKET (for Radio and Display Type)

    1. E345098

      Remove the 3 screws and No. 2 radio bracket.