CAUTION / NOTICE / HINT
Tech Tips
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
A bolt without a torque specification is shown in the standard bolt chart Click here.
PROCEDURE
INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH
Install the front axle hub to the steering knuckle with the 4 bolts.
INSTALL STEERING KNUCKLE SUB-ASSEMBLY LH
Install the steering knuckle to the front lower ball joint with the 3 bolts.
CONNECT FRONT NO. 1 SUSPENSION UPPER ARM ASSEMBLY LH
CONNECT FRONT NO. 2 SUSPENSION UPPER ARM ASSEMBLY LH
CONNECT TIE ROD ASSEMBLY LH
INSTALL FRONT SPEED SENSOR LH
CONNECT SKID CONTROL SENSOR WIRE
INSTALL FRONT DISC BRAKE DUST COVER LH
INSTALL FRONT DISC
CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH
INSTALL FRONT AXLE SHAFT NUT LH
DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH
REMOVE FRONT DISC
INSPECT FRONT AXLE HUB BEARING LOOSENESS
INSPECT FRONT AXLE HUB RUNOUT
INSTALL FRONT DISC
CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH
STAKE FRONT AXLE SHAFT NUT LH
INSTALL FRONT WHEEL
INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
Inspect and adjust the front wheel alignment Click here.
CHECK ABS SPEED SENSOR SIGNAL
Check the speed sensor signal Click here.
ADJUST VEHICLE HEIGHT
Adjust the vehicle height Click here.
ADJUST HEADLIGHT ASSEMBLY
Adjust the headlight Click here.