CAUTION / NOTICE / HINT
Tech Tips
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
PROCEDURE
INSTALL BENCH TYPE REAR SEATBACK ASSEMBLY
Note
Be careful not to damage the vehicle body.
Set the bench type rear seatback assembly in place.
Connect the rear center armrest assembly connector.
Attach the 2 hooks on the backside of the bench type rear seatback assembly.
Install the 4 bolts and nut.
w/ Seat Heater System:
Connect the connector.
Install the junction block with the bolt.
Attach the hook to the rear seat armrest hole board. Then attach the 2 clips to install the rear seat armrest hole board.
While pressing the button, raise the rear center seat headrest assembly.
Raise the rear center armrest assembly.
Connect the rear seat outer belt to the rear seat shoulder belt guide.
Tech Tips
Use the same procedure to connect the rear seat outer belt on the other side.
Attach the 2 claws to close the 2 caps of the rear seat shoulder belt guide.
Tech Tips
Use the same procedure to close the 2 caps on the other side.
Connect the 2 seat belt anchors of the rear seat 3 point type belt assembly LH and rear seat 3 point type belt assembly RH with the 2 bolts and connect the seat belt anchor of the rear center seat outer belt assembly with the nut.
INSTALL BENCH TYPE REAR SEAT CUSHION ASSEMBLY
Note
Be careful not to damage the vehicle body.
Set the bench type rear seat cushion assembly in place.
*A | w/ Seat Heater System |
w/ Seat Heater System:
Connect the 2 connectors.
Attach the 2 rear hooks of the bench type rear seat cushion assembly to the bench type rear seatback assembly.
Attach the 3 front hooks to install the bench type rear seat cushion assembly.
Confirm that the bench type rear seat cushion assembly is firmly installed.
Note
When installing the bench type rear seat cushion assembly, make sure the seat belt buckle is not under the bench type rear seat cushion assembly.
CHECK SEAT HEATER SYSTEM (w/ Seat Heater System)
CHECK REAR SUNSHADE SYSTEM (w/ Sunshade)