PROCEDURE
INSTALL NO. 2 INSTRUMENT PANEL WIRE
Connect the 2 airbag connectors of the No. 2 instrument panel wire to the instrument panel passenger airbag assembly.
*1 | Airbag Connector |
*2 | Airbag Connector Lock |
When connecting any airbag connector, take care not to damage the airbag wire harness.
Be sure to only connect the connectors to each corresponding color.
Push in the 2 airbag connector locks to install the 2 airbag connectors to the instrument panel passenger airbag assembly.
Engage the clamp.
INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
Engage the 3 hooks.
Push in the instrument panel passenger airbag assembly to engage the 3 hooks.
Install the 2 screws to install the instrument panel passenger airbag assembly.
Engage the 2 clamps.
INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY
CONNECT NO. 2 INSTRUMENT PANEL WIRE
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Connect the connector.
When connecting any airbag connector, take care not to damage the airbag wire harness.
INSTALL INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
PERFORM DIAGNOSTIC SYSTEM CHECK