PROCEDURE
INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
*1 | Airbag Connector Lock |
*2 | Airbag Connector |
Connect the airbag connector to the lower No. 2 instrument panel airbag assembly.
Note
When connecting any airbag connector, take care not to damage the airbag wire harness.
Push in the airbag connector lock to install the airbag connector.
Engage the 5 claws and 2 guides to temporarily install the lower No. 2 instrument panel airbag assembly.
Install the 3 bolts.
Note
Confirm that the lower No. 2 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
INSTALL INSTRUMENT SIDE PANEL RH
INSTALL FRONT DOOR OPENING TRIM COVER RH
Tech Tips
Use the same procedure for the RH side and LH side Click here.
INSTALL COWL SIDE TRIM BOARD RH
Tech Tips
Use the same procedure for the RH side and LH side Click here.
INSTALL FRONT DOOR SCUFF PLATE RH
Tech Tips
Use the same procedure for the RH side and LH side Click here.
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSTALL LUGGAGE TRIM SERVICE HOLE COVER
PERFORM DIAGNOSTIC SYSTEM CHECK
INSPECT SRS WARNING LIGHT