Click here

KNEE AIRBAG ASSEMBLY(for Driver Side) REMOVAL

Click here
Click here Click here

PROCEDURE


  1. Click here

    PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing (Click here).

    Note:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).

  2. Click here

    REMOVE LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  3. Click here

    DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  4. Click here

    REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL

    Click here

  5. Click here

    REMOVE FRONT DOOR SCUFF PLATE LH

    Click here

  6. Click here

    REMOVE COWL SIDE TRIM BOARD LH

    Click here

  7. Click here

    REMOVE FRONT DOOR OPENING TRIM COVER LH

    Click here

  8. Click here

    REMOVE INSTRUMENT SIDE PANEL LH

    Click here

  9. Click here

    DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

    Click here

  10. Click here

    REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here

  11. Click here

    REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    CAUTION:

    When storing the lower No. 1 instrument panel airbag assembly, keep the airbag deployment side facing upward.


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. A0004WP

      Remove the 4 bolts.

    4. Disengage the 2 hooks to separate the lower No. 1 instrument panel airbag assembly.

      Note:

      When removing the lower No. 1 instrument panel airbag assembly, do not pull the airbag wire harness.

    5. A000541

      Disengage the 2 claws to disconnect the DLC3.

    6. Disconnect the connector and disengage the clamp to remove the wire harness.

    7. A0006DEE05

      Using a screwdriver with its tip wrapped with protective tape, release the airbag connector lock.

      Table 1. Text in Illustration
      *1 Protective Tape
      *2 Airbag Connector
      *3 Airbag Connector Lock
    8. Disconnect the airbag connector to remove the lower No. 1 instrument panel airbag assembly.

      Note:

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

  12. Click here

    REMOVE TIRE PRESSURE WARNING RESET SWITCH

    Click here