DTC Code | DTC Name |
---|---|
U0200 | Lost Communication with "Door Control Module B" |
DESCRIPTION
DTC No. | DTC Detection Condition | Trouble Area |
---|---|---|
U0200 | No communication from the outer mirror control ECU assembly LH continues. |
|
This diagnosis procedure is for when DTC U0200 is output by the main body ECU (multiplex network body ECU) (GTS display: Main Body).
CAUTION / NOTICE / HINT
Before measuring the resistance of the CAN bus, turn the power switch off and leave the vehicle for 1 minute or more without operating the key, switches or opening or closing the doors. After that, disconnect the cable from the negative (-) auxiliary battery terminal and leave the vehicle for 1 minute or more before measuring the resistance.
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).
Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output (Click here).
After performing repairs, perform the DTC check procedure and confirm that the DTCs are not output again.
DTC check procedure: Turn the power switch on (IG) and wait at least 20 seconds.
After the repair, perform CAN Bus Check and check that all the ECUs and sensors connected to the CAN communication system are displayed (Click here).
Operating the power switch, any other switches or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may help determine the cause of the malfunction.
PROCEDURE
RECONFIRM DTC OUTPUT
Reconfirm DTCs.
If DTC U1002 is output from Main Body of the main body ECU (multiplex network body ECU), this indicates a sub bus 1 malfunction. Troubleshoot for DTC U1002 and check for malfunctions in the sub bus 1.
Result | ||||||
---|---|---|---|---|---|---|
|
GO TO DIAGNOSIS PROCEDURE INDICATED BY OUTPUT DTC (Click here)
CHECK FOR OPEN IN SUB BUS 1 LINES (OUTER MIRROR CONTROL ECU ASSEMBLY LH BRANCH LINE)
Disconnect the cable from the negative (-) auxiliary battery terminal.
Disconnect the M9 outer mirror control ECU assembly LH connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance | ||||||
---|---|---|---|---|---|---|
|
*a | Front view of wire harness connector (to Outer Mirror Control ECU Assembly LH) |
REPAIR OR REPLACE CAN BRANCH LINE OR CONNECTOR (OUTER MIRROR CONTROL ECU ASSEMBLY LH)
CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)
Measure the resistance according to the value(s) in the table below.
Standard Resistance | ||||||
---|---|---|---|---|---|---|
|
*a | Front view of wire harness connector (to Outer Mirror Control ECU Assembly LH) |
Reconnect the cable to the negative (-) auxiliary battery terminal.
Measure the voltage according to the value(s) in the table below.
Standard Voltage | |||||||||
---|---|---|---|---|---|---|---|---|---|
|
*a | Front view of wire harness connector (to Outer Mirror Control ECU Assembly LH) |
REPLACE OUTER MIRROR CONTROL ECU ASSEMBLY LH (Click here)
REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)