PROCEDURE
PRECAUTION
REMOVE SERVICE PLUG GRIP
REMOVE CONNECTOR COVER ASSEMBLY
CHECK TERMINAL VOLTAGE
INSTALL CONNECTOR COVER ASSEMBLY
REMOVE REAR SEAT ASSEMBLY
REMOVE ROOM PARTITION PANEL INSULATOR
REMOVE NO. 4 HYBRID BATTERY SHIELD PANEL
CAUTION:
Wear insulated gloves.
*1 | Service Plug Grip |
*2 | Battery Cover Lock Striker |
*3 | Button |
*a | Projection |
*b | Turn |
Using the service plug grip, remove the battery cover lock striker.
Tech Tips
Insert the projection part of the service plug grip, and turn the button of the battery cover lock striker counterclockwise to release the lock.
Remove the bolt, 2 nuts and No. 4 hybrid battery shield panel.
DISCONNECT FRAME WIRE
CAUTION:
Wear insulated gloves.
*1 | Shield Wire Ground |
Disconnect the shield wire ground from the No. 1 hybrid battery shield sub-assembly.
Disconnect the 2 connectors from the hybrid battery junction block assembly.
Note
Insulate the disconnected connectors with insulating tape.
REMOVE NO. 1 HYBRID BATTERY SHIELD SUB-ASSEMBLY
CAUTION:
Wear insulated gloves.
Disconnect the connector and wire harness clamp.
Remove the bolt, 3 nuts and No. 1 hybrid battery shield sub-assembly from the HV battery.
REMOVE HYBRID BATTERY JUNCTION BLOCK ASSEMBLY
CAUTION:
Wear insulated gloves.
Disengage the claw and disconnect the terminal cover.
Using an insulated tool, remove the 2 bolts from the hybrid battery junction block assembly.
Note
Insulate the disconnected terminals with insulating tape.
Disconnect the connector from the hybrid battery junction block assembly.
Remove the 3 bolts and hybrid battery junction block assembly from the HV battery.