TRANSMISSION WIRE REMOVAL

PROCEDURE


  1. DRAIN AUTOMATIC TRANSMISSION FLUID


    1. B001G15

      Remove the drain plug and gasket from the automatic transmission assembly and drain the ATF.

    2. Install a new gasket and the drain plug to the automatic transmission assembly.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }
  2. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY


    1. A01XHHV

      Remove the 10 bolts, automatic transmission oil pan sub-assembly and automatic transmission oil pan gasket from the automatic transmission case sub-assembly.

      Note

      Some fluid will remain in the automatic transmission oil pan sub-assembly. Remove all of the bolts, and carefully remove the automatic transmission oil pan sub-assembly.

    2. Remove the 4 transmission oil cleaner magnets from the automatic transmission oil pan sub-assembly.

    3. Examine the particles in the automatic transmission oil pan sub-assembly.


      1. Collect any steel chips with the removed transmission oil cleaner magnets. Carefully inspect the foreign matter and particles in the automatic transmission oil pan sub-assembly and on the transmission oil cleaner magnets to anticipate the type of wear you will find in the automatic transmission assembly.

        Steel (magnetic): bearing, gear and clutch plate wear

        Brass (non-magnetic): bush wear

  3. DISCONNECT TRANSMISSION WIRE


    1. A01XG7HE04
      Text in Illustration
      *1 Temperature Sensor Clamp
      *2 Temperature Sensor

      Remove the 2 bolts and the 2 temperature sensor clamps, and disconnect the 2 temperature sensors.

    2. Disconnect the 7 solenoid valve connectors and transmission wire from the transmission valve body assembly.

  4. REMOVE TRANSMISSION INSULATOR RH


    1. A01XISJ

      w/ ATF Warmer:

      Remove the bolt and wire harness clamp bracket from the transmission insulator RH.


      1. Remove the 2 bolts and transmission insulator RH from the automatic transmission assembly.

    2. w/o ATF Warmer:


      1. A01XE5T

        Remove the 3 bolts and transmission insulator RH from the automatic transmission assembly.

  5. REMOVE TRANSMISSION WIRE


    1. A01XGX8

      Disconnect the transmission wire connector.

      Tech Tips

      Detach the claw, press down the lever, and disconnect the transmission wire connector.

    2. Remove the bolt and pull out the transmission wire from the automatic transmission case sub-assembly.

    3. A01XEI2

      Remove the O-ring from the connector of transmission wire.

    4. A01XMF8

      Remove the 2 O-rings from the 2 temperature sensors.