CAUTION / NOTICE / HINT
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.
PROCEDURE
PRECAUTION
Note
After turning the ignition switch off, waiting time may be required before disconnecting the cable from auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.
REMOVE FRONT FLOOR COVER RH (for Front Floor Cover Type A)
REMOVE CENTER FRONT FLOOR COVER (for Front Floor Cover Type B)
REMOVE FRONT FLOOR COVER RH (for Front Floor Cover Type B)
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE REAR CONSOLE BOX
REMOVE AIRBAG SENSOR ASSEMBLY
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
*1 | Lever |
Pull the lever down and disconnect the connector holder.
Note
When disconnecting the airbag connector, take care not to damage the airbag wire harness.
Remove the 3 bolts and the airbag sensor assembly.