DESCRIPTION
The power management control ECU turns on the cruise control indicator light by sending indicator output demand signals to the combination meter assembly using CAN communication.
The cruise control indicator light illuminates in green when the cruise control system has been turned on using the ON-OFF switch. If a malfunction is detected, the cruise control indicator light changes to amber.
The cruise control indicator light circuit uses CAN communication. If the cruise control indicator light is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.
WIRING DIAGRAM
*1 | Combination Meter Assembly |
*2 | Power Management Control ECU |
*3 | CAN Communication Line |
PROCEDURE
PERFORM ACTIVE TEST USING GTS
Connect the GTS to the DLC3.
Turn the ignition switch to ON (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
Check the cruise control indicator light by performing the Active Test.
Tester Display | Test Part | Control Range | Diagnostic Note |
---|---|---|---|
Indicat. Lamp Cruise | Cruise control indicator light | Cruise control indicator light (illuminated in green) ON / OFF | - |
Cruise Indicator | Cruise control indicator light | Cruise control indicator light (illuminated in amber) ON / OFF | - |
Cruise control indicator light
OK |
---|
The cruise control indicator light goes on or off. |
OK |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here |
NG |
REPLACE COMBINATION METER ASSEMBLY Click here |