PROCEDURE
DRAIN BRAKE FLUID
Note
Immediately wash off any brake fluid that comes into contact with any painted surfaces.
REMOVE BATTERY
REMOVE BATTERY TRAY
REMOVE BATTERY CARRIER (for 1KR-FE)
Disengage the 5 wire harness clamps and disconnect the wire harness from the battery carrier.
Remove the 4 bolts and battery carrier.
REMOVE BATTERY CARRIER (for 1NR-FE)
REMOVE BRAKE ACTUATOR ASSEMBLY
*1 | Lock lever |
Release the lock lever and disconnect the brake actuator connector.
Note
Be careful not to allow brake fluid to enter the removed connector.
Using union nut wrench 10 mm and union nut wrench 12 mm, separate the 6 brake tubes from the brake actuator.
Flare Nut 10 mm | |
Flare Nut 12 mm |
Remove the 3 bolts and brake actuator with bracket.
Note
Do not damage the brake tubes or wire harness.
REMOVE BRAKE ACTUATOR BRACKET ASSEMBLY
Remove the 3 bolts and brake actuator bracket assembly.
REMOVE BRAKE ACTUATOR BOLT CUSHION
Remove the 3 brake actuator case collars from the brake actuator bolt cushion.
Remove the 3 brake actuator bolt cushions from the brake actuator bracket assembly.