FRONT PASSENGER AIRBAG ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedures listed below are for RHD vehicles.

PROCEDURE


  1. INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY


    1. B003OOWC01
      B003OFB Slowly Pull

      Attach the hook on the side of the airbag door facing the rear of the vehicle and set the instrument panel passenger airbag assembly onto the airbag door.

    2. Slowly pull the instrument panel passenger airbag assembly in the direction indicated by the arrow shown in the illustration to attach the hook on the side of the airbag door facing the rear of the vehicle and install the instrument panel passenger airbag assembly.

    3. Install the 2 screws.

    4. B003Q8YC01
      *a Connector Lock
      B003OFB Push in this Direction

      Attach the wire harness clamp.

    5. Connect the airbag connector and push the connector lock.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

  2. INSTALL UPPER INSTRUMENT PANEL

    Click here

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. PERFORM DIAGNOSTIC SYSTEM CHECK

    for Type A:

    Click here

    for Type B:

    Click here

  5. CHECK SRS WARNING LIGHT

    for Type A:

    Click here

    for Type B:

    Click here