TRANSMITTER BATTERY REPLACEMENT

PROCEDURE


  1. REMOVE TRANSMITTER BATTERY

    Note

    Take extra care when handling these precision electronic components.


    1. A01RH5FC02
      *a Release Hook Knob
      B004PRK Slide
      B004PI4 Remove in this Direction

      Slide the release hook knob and remove the mechanical key as shown in the illustration.

    2. A01RIWUC02
      *a Protective Tape

      Insert a screwdriver into the gap, and turn the screwdriver to remove the transmitter housing cover.

      Tech Tips

      Tape the screwdriver tip before use.

    3. A01RJ3HC02
      *a Protective Tape
      B004PI4 Remove in this Direction

      Insert a precision screwdriver into the gap and gently remove the transmitter battery (lithium battery: CR2032) as shown in the illustration.

      Note


      • Do not push the terminals with your finger.

      • Do not forcibly pry up the transmitter battery as the terminals may be damaged.

      • Do not touch the transmitter battery with wet hands. Moisture may cause rust.

      • Do not touch or move any components inside the transmitter housing case. It may interfere with proper operation.

      • When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical key transmitter sub-assembly from being damaged.

      Tech Tips

      Tape the screwdriver tip before use.

  2. INSTALL TRANSMITTER BATTERY


    1. A01RHL3C02
      B004PI4 Install in this Direction

      Install a new transmitter battery (lithium battery: CR2032) with the positive (+) side facing upward, as shown in the illustration.

      Note


      • Do not bend the transmitter battery electrode during installation.

      • Keep the inside of the transmitter housing cover free of dust and oil.

      • When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical key transmitter sub-assembly from being damaged.

    2. A01RJX6C02
      B004PI4 Install in this Direction

      Install the transmitter housing cover by pressing down on it as shown in the illustration.

    3. A01RHHAC02
      B004PI4 Install in this Direction

      Insert the mechanical key into the transmitter as shown in the illustration.

    4. Press one of the transmitter switches and check that the LED illuminates.

      OK
      Transmitter LED illuminates when a switch is pressed.