CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during cruise control main switch removal/installation are shown below.
Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
---|---|---|---|
Disconnect cable from negative auxiliary battery terminal | Memorize steering angle neutral point | Lane departure alert system (w/ Steering Control) | |
Intelligent clearance sonar system*1 | |||
Simple intelligent parking assist system*1 | |||
Pre-crash safety system | |||
Parking assist monitor system | |||
Initialize back door lock | Power door lock control system |
*1: When performing learning using the GTS.
PROCEDURE
REMOVE HORN BUTTON ASSEMBLY
REMOVE CRUISE CONTROL MAIN SWITCH
Remove the 2 screws.
Remove in this Direction |
Pull the cruise control main switch as shown in the illustration.
Disconnect the connector to remove the cruise control main switch.