PROCEDURE
PRECAUTION
Note
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
REMOVE INTAKE PIPE
Remove the 2 bolts.
Loosen the 2 hose clamps and remove the intake pipe.
REMOVE NO. 1 GLOW PLUG CONNECTOR
*1 | Nut |
*2 | Plate Washer |
*3 | No. 2 Glow Plug Resistor Insulator |
*4 | Wire Harness |
*5 | No. 1 Glow Plug Resistor Insulator |
Remove the nut, plate washer and No. 2 glow plug resistor insulator and disconnect the wire harness.
Remove the 4 screw grommets, 4 nuts and No. 1 glow plug connector.
Remove the No. 1 glow plug resistor insulator.
REMOVE GLOW PLUG ASSEMBLY
Using a 12 mm deep socket wrench, remove the 4 glow plug assemblies.