STEERING WHEEL REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the steering wheel assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Intelligent clearance sonar system
Simple intelligent parking assist system
Pre-crash safety system
Parking assist monitor system

Click here

Initialize back door lock Power door lock control system

Click here

Note


  • Do not replace the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch on (IG).

  • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed with the auxiliary battery connected and the power switch on (IG).

  • Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.

PROCEDURE


  1. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  2. REMOVE HORN BUTTON ASSEMBLY

    Click here

  3. REMOVE STEERING WHEEL ASSEMBLY


    1. A01RJFI

      Disconnect 2 connectors from the spiral cable with sensor sub-assembly.

    2. A01RJIDC01
      *a Matchmark

      Remove the steering wheel assembly set nut.

    3. Put matchmarks on the steering wheel assembly and steering main shaft.

    4. A01RHYCC01
      *a Turn
      *b Hold

      Using SST, remove the steering wheel assembly.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05031 )

      Note

      Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.

  4. REMOVE CRUISE CONTROL MAIN SWITCH

    Click here

  5. REMOVE CRUISE CONTROL SWITCH WIRE


    1. Remove the cruise control switch wire.

  6. REMOVE STEERING PAD SWITCH ASSEMBLY

    Click here

  7. REMOVE LOWER STEERING WHEEL BOSS COVER


    1. A01RKCT

      Disengage the 6 claws and 4 pins to remove the lower steering wheel boss cover from the steering wheel sub-assembly.