PROCEDURE
INSTALL FRONT DIFFERENTIAL CARRIER ASSEMBLY
Install the front No. 3 differential support to the front differential carrier assembly with the 2 bolts.
Support the front differential with a jack.
Install the front differential carrier assembly.
*a | Rear of Vehicle | *b | Side of Vehicle |
Install in this Direction | - | - |
Install the differential mount nut.
*1 | Upper Differential Mount Stopper |
*2 | Lower Differential Mount Stopper |
Install the upper differential mount stopper and lower differential mount stopper to the front No. 2 differential support.
Install the front No. 2 mounting support with the 3 bolts and nut.
*1 | Upper Differential Mount Stopper |
*2 | Lower Differential Mount Stopper |
Install the upper differential mount stopper and lower differential mount stopper to the front No. 1 differential support.
Install the front No. 1 mounting support with the 4 bolts and nut.
Install the bracket with the bolt.
Connect the differential motor actuator connector.
Install the bracket with the bolt.
Connect the oil temperature sensor connector.
Connect the hose to the front differential union.
Install the differential breather tube bracket with the bolt.
Connect the breather hose to the differential breather tube bracket.
Lower the jack.
INSTALL POWER STEERING LINK ASSEMBLY
Install the power steering link assembly with the 2 bolts, 2 washers and 2 nuts.
CONNECT STEERING SLIDING YOKE
INSTALL CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)
Install the bracket with the bolt.
Install the clutch release cylinder with the 2 bolts.
INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
Tech Tips
Use the same procedure described for the LH side.
INSTALL FRONT PROPELLER SHAFT ASSEMBLY
ADD DIFFERENTIAL OIL
INSTALL NO. 2 ENGINE UNDER COVER
INSTALL NO. 1 ENGINE UNDER COVER