PROCEDURE
ADJUST TIE ROD END SUB-ASSEMBLY
Adjust the tie rod end sub-assembly LH and RH so that distance A is within the specified ranges.
Standard Length (A) |
---|
17 mm (0.6693 in.) or less |
CAUTION:
Make sure to tighten the nut in the alignment adjustment procedure.
Note
Make sure that the boots are not twisted.
Tech Tips
The values listed above are reference values.
The toe-in is adjusted in another step.
INSTALL POWER STEERING LINK ASSEMBLY
Install the power steering link assembly with the 2 bolts, 2 washers and 2 nuts.
*a | Torque Wrench Fulcrum Length |
Using a union nut wrench, connect the steering gear outlet return tube.
Tech Tips
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
When using a union nut wrench (fulcrum length of 30 mm (1.1811 in.)) + torque wrench (fulcrum length of 180 mm (7.0866 in.)): 21.4 N*m (218 kgf*cm, 16 ft.*lbf)
Install the hose with the clip.
Install the pressure feed tube assembly bracket to the power steering link assembly with the bolt.
*a | Torque Wrench Fulcrum Length |
Using a union nut wrench, tighten the flare nut and connect the pressure feed tube assembly.
Tech Tips
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
When using a union nut wrench (fulcrum length of 30 mm (1.1811 in.)) + torque wrench (fulcrum length of 180 mm (7.0866 in.)): 21.4 N*m (218 kgf*cm, 16 ft.*lbf)
INSTALL FRONT DIFFERENTIAL CARRIER ASSEMBLY
CONNECT NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY
Align the matchmarks on the No. 2 steering intermediate shaft sub-assembly and power steering link assembly.
Install the bolt.
CONNECT STEERING SLIDING YOKE
*a | Matchmark |
Install in this Direction |
Align the matchmarks on the steering sliding yoke and No. 2 steering intermediate shaft, and connect the steering sliding yoke to the No. 2 steering intermediate shaft sub-assembly.
Install the bolt labeled B.
Tighten the bolt labeled A.
CONNECT TIE ROD END SUB-ASSEMBLY LH
Connect the tie rod end sub-assembly LH to the front axle hub assembly with a new nut.
Install a new cotter pin.
Note
If the holes for the cotter pin are not aligned, tighten the nut an additional 60°.
CONNECT TIE ROD END SUB-ASSEMBLY RH
Tech Tips
Use the same procedure described for the LH side.
INSTALL NO. 2 ENGINE UNDER COVER
INSTALL NO. 1 NGINE UNDER COVER ASSEMBLY
INSTALL FRONT WHEELS
ADD POWER STEERING FLUID
ADJUST POWER STEERING FLUID
CHECK FOR POWER STEERING FLUID LEAK
ADJUST FRONT WHEEL ALIGNMENT