CAUTION / NOTICE / HINT
Tech Tips
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
If the front speed sensor rotor needs to be replaced, replace the front axle hub sub-assembly.
PROCEDURE
REMOVE FRONT WHEEL
SEPARATE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY
Remove the screw and clip to separate the front fender splash shield sub-assembly.
REMOVE FRONT SPEED SENSOR (w/o AVS)
Turn back the front fender splash shield sub-assembly.
Disconnect the front speed sensor connector.
Disengage the 2 sensor clamps.
Remove the bolt and sensor clamp.
Remove the bolt and separate the front flexible hose and sensor clamp.
Disengage the 2 claws to separate the sensor clamp.
Remove the bolt and front speed sensor from the steering knuckle.
Note
Keep the tip of the front speed sensor and installation hole free of foreign matter.
Do not rotate or apply excessive force to the front speed sensor when removing it from the steering knuckle. Rotating or applying excessive force may result in damage to the front speed sensor.
REMOVE FRONT SPEED SENSOR (w/ AVS)
Disconnect the front speed sensor connector.
Remove the bolt and front speed sensor from the steering knuckle.
Note
Keep the tip of the front speed sensor and installation hole free of foreign matter.
Do not rotate or apply excessive force to the front speed sensor when removing it from the steering knuckle. Rotating or applying excessive force may result in damage to the front speed sensor.
REMOVE FRONT SKID CONTROL SENSOR WIRE (w/ AVS)
Turn back the front fender splash shield sub-assembly.
Disconnect the front skid control sensor wire connector.
Disengage the 2 sensor clamps.
Remove the bolt and sensor clamp.
Remove the bolt and separate the front flexible hose and sensor clamp.
Disconnect the connector from the front shock absorber assembly.
Remove the bolt and front skid control sensor wire from the front shock absorber assembly.