RADIO RECEIVER REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  3. REMOVE NO. 1 METER HOOD CLUSTER

    Click here

  4. REMOVE NO. 2 METER HOOD CLUSTER

    Click here

  5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

    Click here

  6. REMOVE UPPER INSTRUMENT CENTER CLUSTER FINISH PANEL

    Click here

  7. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET

    A005ID7

    1. Remove the 4 screws.

    2. Disengage the 4 clips and pull the radio receiver assembly with bracket toward the rear of the vehicle.

    3. Disconnect each connector and remove the radio receiver assembly with bracket.

  8. REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY

    Click here

  9. REMOVE NO. 1 RADIO BRACKET


    1. A005K3N

      Remove the 3 screws and remove the No. 1 radio bracket from the radio receiver assembly.

  10. REMOVE NO. 2 RADIO BRACKET


    1. A005GJQ

      Remove the 3 screws and remove the No. 2 radio bracket from the radio receiver assembly.