CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the air fuel ratio sensor removal/installation are shown below.
Replacement Part or Procedure | Necessary Procedures | Effects/Inoperative when not Performed | Link |
---|---|---|---|
|
Inspection After Repair | Poor idle, engine start, etc. |
CAUTION:
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
PROCEDURE
REMOVE FRONT FENDER SEAL RH
REMOVE AIR FUEL RATIO SENSOR
CAUTION:
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
Disconnect the air fuel ratio sensor connector.
Detach the 3 wire harness clamps.
Using SST, remove the air fuel ratio sensor.