ROOF HEADLINING(for Wagon) INSTALLATION
PROCEDURE
INSTALL ROOF HEADLINING ASSEMBLY (for Standard Roof)
-
Pull the roof headlining assembly into the vehicle through the back door as shown in the illustration.
Note:Do not damage the roof headlining assembly or vehicle interior.
-
Engage the 2 claws.
Tip:Use the same procedure for the RH side and LH side.
Push in the visor holder as shown in the illustration.
Tip:Use the same procedure for the RH side and LH side.
Install the roof headlining assembly with the 5 clips.
for LHD Front Pillar LH Side:
Engage the 6 clamps.
Connect the connector.
for RHD Front Pillar LH Side:
Engage the 5 clamps.
Connect the connector.
for Front Pillar RH Side:
Engage the 3 clamps.
Connect the connector.
for Rear Pillar RH Side:
Connect the connector.
Engage the guide.
Connect the connector bracket with the bolt.
7.0 N*m
71 kgf*cm
62 in.*lbf
w/ EC Mirror:
Connect the connector.
w/ Rain Sensor:
Connect the connector.
w/ Pre-crash Safety System:
Connect each connector.
-
INSTALL ROOF HEADLINING ASSEMBLY (for Glass Roof)
-
Pull the roof headlining assembly into the vehicle through the back door as shown in the illustration.
Note:Do not damage the roof headlining assembly or vehicle interior.
Engage the guide.
-
Engage the 2 claws.
Tip:Use the same procedure for the RH side and LH side.
Push in the visor holder as shown in the illustration.
Tip:Use the same procedure for the RH side and LH side.
Engage the 14 fasteners.
Tip:Engage the fasteners from the front side of the roof headlining assembly.
Install the roof headlining assembly with the 3 clips.
for LHD Front Pillar LH Side:
Engage the 6 clamps.
Connect the connector.
for RHD Front Pillar LH Side:
Engage the 5 clamps.
Connect the connector.
for Front Pillar RH Side:
Engage the 3 clamps.
Connect the connector.
for Rear pillar LH Side:
Connect the connector.
for Rear Pillar RH Side:
Connect the connector.
Engage the guide.
Connect the connector bracket with the bolt.
7.0 N*m
71 kgf*cm
62 in.*lbf
w/ EC Mirror:
Connect the connector.
w/ Rain Sensor:
Connect the connector.
w/ Pre-crash Safety System:
Connect each connector.
-
INSTALL REAR ROOM PARTITION NET HOOK LH
Tip:Use the same procedure for the front side and rear side.
Engage the guide and claw.
Install the rear room partition net hook LH with the screw.
Close the cover.
INSTALL REAR ROOM PARTITION NET HOOK RH
Tip:Use the same procedure as for the LH side.
INSTALL VISOR ASSEMBLY LH
INSTALL VISOR ASSEMBLY RH
Tip:Use the same procedure as for the LH side.
INSTALL ASSIST GRIP ASSEMBLY
INSTALL REAR ASSIST GRIP ASSEMBLY LH
INSTALL REAR ASSIST GRIP ASSEMBLY RH
Tip:Use the same procedure as for the LH side.
INSTALL NO. 1 ROOM LIGHT ASSEMBLY (for Slide Switch Type)
INSTALL MAP LIGHT ASSEMBLY
INSTALL PRE-CRASH SAFETY CITY COVER (w/ Pre-crash Safety System)
INSTALL PRE-CRASH SAFETY CITY COVER 2ND (w/ Pre-crash Safety System)
INSTALL RAIN SENSOR COVER (w/ Rain Sensor)
INSTALL INNER REAR VIEW MIRROR STAY HOLDER COVER (w/ EC Mirror)
INSTALL UPPER INSTRUMENT PANEL
INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH
Install a new clip (A) to the roof side inner garnish assembly LH.
Engage the 2 claws and 4 clips.
Install the roof side inner garnish assembly LH with the 2 screws.
INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
Engage the clamp.
Connect each connector.
Engage the 7 claws and 4 clips, and install the deck trim side panel assembly LH with the 2 bolts.
*A
w/o Deck Board
*B
w/ Deck Board
Bolt (A)
11 N*m
112 kgf*cm
8 ft.*lbf
w/ Deck Board:
Engage the 2 clips.
Install the deck side trim box LH with the clip.
Engage the guide.
Install the luggage hold belt striker assembly with the bolt.
INSTALL RECLINING REMOTE CONTROL BEZEL LH
-
Engage the 3 claws to install the reclining remote control bezel LH.
-
INSTALL NO. 2 DECK SIDE TRIM HOOK (for LH Side)
Engage the pin.
Install the No. 2 deck side trim hook with the screw.
INSTALL REAR SEAT SIDE GARNISH LH
INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY LH
Engage the guide.
Install the rear seatback hinge sub-assembly LH with the bolt.
18 N*m
184 kgf*cm
13 ft.*lbf
INSTALL ROOF SIDE INNER GARNISH ASSEMBLY RH
Tip:Use the same procedure as for the LH side.
INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH
Tip:Use the same procedure as for the LH side.
INSTALL RECLINING REMOTE CONTROL BEZEL RH
Tip:Use the same procedure as for the LH side.
INSTALL NO. 2 DECK SIDE TRIM HOOK (for RH Side)
Tip:Use the same procedure as for the LH side.
INSTALL REAR SEAT SIDE GARNISH RH
Tip:Use the same procedure as for the LH side.
INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY RH
Tip:Use the same procedure as for the LH side.
INSTALL CENTER PILLAR GARNISH ASSEMBLY LH
INSTALL CENTER PILLAR LOWER GARNISH LH
CONNECT FRONT SEAT OUTER BELT ASSEMBLY LH
INSTALL LAP BELT OUTER ANCHOR COVER (for LH Side)
INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
-
*a
Alignment Mark (Light Blue)
*b
Flange Position
Align the alignment mark (light blue) on the weatherstrip with the flange on the vehicle body indicated by the arrow in the illustration, and install the rear door opening trim weatherstrip LH.
Note:After installation, check that the corners fit correctly.
-
INSTALL REAR DOOR SCUFF PLATE LH
INSTALL FRONT PILLAR GARNISH LH
INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
INSTALL COWL SIDE TRIM BOARD LH
INSTALL FRONT DOOR SCUFF PLATE LH
INSTALL CENTER PILLAR GARNISH ASSEMBLY RH
Tip:Use the same procedure as for the LH side.
INSTALL CENTER PILLAR LOWER GARNISH RH
Tip:Use the same procedure as for the LH side.
CONNECT FRONT SEAT OUTER BELT ASSEMBLY RH
Tip:Use the same procedure as for the LH side.
INSTALL LAP BELT OUTER ANCHOR COVER (for RH Side)
Tip:Use the same procedure as for the LH side.
INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH
-
*a
Alignment Mark (White)
*b
Flange Position
Align the alignment mark (white) on the weatherstrip with the flange on the vehicle body indicated by the arrow in the illustration, and install the rear door opening trim weatherstrip RH.
Note:After installation, check that the corners fit correctly.
-
INSTALL REAR DOOR SCUFF PLATE RH
Tip:Use the same procedure as for the LH side.
INSTALL FRONT PILLAR GARNISH RH
Tip:Use the same procedure as for the LH side.
INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH
INSTALL COWL SIDE TRIM BOARD RH
Tip:Use the same procedure as for the LH side.
INSTALL FRONT DOOR SCUFF PLATE RH
Tip:Use the same procedure as for the LH side.
INSTALL REAR SEAT ASSEMBLY
INSTALL REAR DECK TRIM COVER
Engage the 2 guides and 4 clips to install the rear deck trim cover.
Engage the 2 guides.
Install the 2 luggage hold belt striker assemblies with the 2 bolts.
INSTALL ROOM PARTITION NET ASSEMBLY (w/ Partition Net)
Install the room partition net assembly.
INSTALL TONNEAU COVER ASSEMBLY
Install the tonneau cover assembly.
INSTALL DECK FLOOR BOX LH (w/o Woofer)
Engage the 2 guides to install the deck floor box LH.
INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY (w/ Deck Board)
Install the No. 3 deck board sub-assembly.
INSTALL DECK FLOOR BOX RH
Engage the 4 guides.
Install the deck floor box RH with the bolt and clip.
INSTALL NO. 2 DECK BOARD SUB-ASSEMBLY (w/ Deck Board)
Install the No. 2 deck board sub-assembly.
INSTALL REAR FLOOR MAT ASSEMBLY
Install the rear floor mat assembly.
INSTALL FRONT DECK FLOOR BOX (w/ Deck Board)
Install the front deck floor box.
INSTALL DECK BOARD ASSEMBLY (w/ Deck Board)
Install the deck board assembly.
INSTALL DECK BOARD SUB-ASSEMBLY (w/ Deck Board)
Install the deck board sub-assembly.