PROCEDURE
INSTALL THERMOSTAT
*1 | Gasket |
*a | CORRECT |
*b | INCORRECT |
*c | Upward |
*d | Jiggle Valve |
Install a new gasket to the thermostat.
Tech Tips
When installing the thermostat to the gasket, be careful not to deform the gasket. Make sure that the thermostat is properly installed into the groove of the gasket as shown in the illustration.
Insert the thermostat into the timing chain cover sub-assembly with the jiggle valve facing straight upward.
Tech Tips
The jiggle valve may be set within 10° of either side of the prescribed position.
INSTALL WATER INLET
Install a new gasket and the water inlet with the 2 nuts and bolt.
Connect the power steering oil pressure switch connector.
CONNECT RADIATOR HOSE OUTLET
Connect the radiator hose outlet to the water inlet, and slide the hose clamp to secure the hose.
Note
Connect the radiator hose outlet so that the paint mark on the radiator hose outlet is aligned with the protrusions of the water inlet.
ADD ENGINE COOLANT
INSPECT FOR COOLANT LEAK
INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY