PROCEDURE
INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY
Tech Tips
Perform "Inspection After Repairs" after replacing the throttle body with motor assembly.
Install a new gasket to the intake air surge tank.
Install the throttle body with motor assembly with the 4 bolts.
Connect the throttle body with motor connector.
Connect the No. 4 water by-pass hose and No. 5 water by-pass hose, and slide the 2 hose clamps to secure the hose.
INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH NO. 1 AIR CLEANER HOSE
Attach the 4 clamps and install the air cleaner cap sub-assembly with No. 1 air cleaner hose.
Tighten the hose clamp.
Connect the No. 2 ventilation hose to the No. 1 air cleaner hose, and slide the clamp to secure the hose.
Connect the vacuum hose to the No. 1 air cleaner hose.
Attach the 2 clamps and connect the intake mass air flow meter connector.
ADD ENGINE COOLANT
INSPECT FOR COOLANT LEAK
PERFORM INITIALIZATION
Note
Perform the following procedure after replacing the throttle body with motor assembly or any throttle body components. The following procedure should also be performed if the throttle body with motor assembly is cleaned.
Turn the ignition switch to ON without operating the accelerator pedal.
Note
If the accelerator pedal is operated, perform the above steps again.
Connect the GTS to the DLC3 and clear the DTCs.
Perform the "Inspection After Repairs".
Start the engine and check that the MIL is not illuminated and that the idle speed is within the specified range when the A/C is switched off after the engine is warmed up.
Standard idle speed |
---|
650 to 750 rpm |
Note
Be sure to perform this step with all accessories off.
Make sure that the shift lever is in N (neutral) or P.
Enter the following menus: Powertrain / Engine / Data List / All Data / Throttle Sensor Position. Fully depress the accelerator pedal and check that the value is 60% or more.
Tester Display |
---|
Throttle Sensor Position |
Perform a road test and confirm that there are no abnormalities.