PROCEDURE
INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Check that the engine switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
*a | Airbag Connector |
*b | Airbag Connector Lock |
*c | DLC3 |
Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Push in the airbag connector lock to install the airbag connector.
Engage the 2 claws to connect the DLC3.
Engage the 2 pins and clamp to temporarily install the lower No. 1 instrument panel airbag assembly.
Install the 4 bolts.
10 N*m | 102 kgf*cm | 7 ft.*lbf |
Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.
INSTALL SKID CONTROL BUZZER (w/ Pre-crash Safety System)
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
INSTALL INSTRUMENT SIDE PANEL LH
INSTALL FRONT DOOR OPENING TRIM COVER LH
INSTALL FRONT DOOR SCUFF PLATE LH
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
PERFORM DIAGNOSTIC SYSTEM CHECK
INSPECT SRS WARNING LIGHT