PROCEDURE
REMOVE COOL AIR INTAKE DUCT SEAL
Remove the 10 clips and cool air intake duct seal.
REMOVE FRONT BUMPER ASSEMBLY
Protective Tape |
Apply protective tape around the front bumper assembly as shown in the illustration.
*1 | Pin Hold Clip |
*a | 90° |
Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
Tech Tips
Use the same procedure for the RH side and LH side.
Remove the screw.
Tech Tips
Use the same procedure for the RH side and LH side.
Remove the 8 screws.
Remove the 3 bolts.
Remove the 2 clips.
*a | Screwdriver |
Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, disengage the 3 claws as shown in the illustration.
Tech Tips
Use the same procedure for the RH side and LH side.
Pull the side of the front bumper assembly and disconnect the 2 connectors.
Note
Do not apply excessive force when pulling back the front bumper assembly.
w/ Headlight Cleaner System:
Disconnect the washer hose and drain the washer fluid.
Tech Tips
Use a container to collect the washer fluid
Disengage the 6 guides and remove the front bumper assembly as shown in the illustration.