PROCEDURE
REMOVE DECK BOARD ASSEMBLY
REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY
REMOVE REAR DECK FLOOR BOX (w/ Spare Tire)
REMOVE DECK FLOOR BOX LH (w/ Spare Tire)
PRECAUTION
Note
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
REMOVE DOOR SCUFF PLATE ASSEMBLY RH (for RHD)
REMOVE COWL SIDE TRIM BOARD RH (for RHD)
REMOVE CONSOLE ARMREST ASSEMBLY
REMOVE UPPER REAR CONSOLE PANEL
REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH
REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH
REMOVE INSTRUMENT SIDE PANEL RH
REMOVE INSTRUMENT SIDE PANEL LH
REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
REMOVE NO. 1 SWITCH HOLE BASE
REMOVE NO. 2 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
REMOVE AIR CONDITIONING CONTROL ASSEMBLY
REMOVE NO. 3 TELEPHONE BRACKET
Remove the nut.
Detach the 2 claws and remove the No. 3 telephone bracket shown in the illustration.
REMOVE MAYDAY BATTERY
CAUTION:
Do not reuse dropped or damaged parts.
Wear gloves when contacting parts that have been dropped from a height of 1 m or higher.
There may be an internal short or the temperature may increase to 100°C or higher due to the shock from being dropped.
f an internal short has occurred, gas may be discharged. Therefore, if there is even a small amount of heat, maintain a distance of 3 m or more from the vehicle and wait for 1 minute or longer.
Disconnect the connector and remove the mayday battery.