BRAKE ACTUATOR(w/o VSC) INSTALLATION
PROCEDURE
INSTALL BRAKE ACTUATOR WITH BRACKET
-
Install the brake actuator with bracket with the 3 nuts. Tighten the 3 bolts uniformly in alphabetical order.
19 N*m
194 kgf*cm
14 ft.*lbf
Note:Do not damage the brake lines or wire harness.
Do not hold the actuator by the connector.
If the actuator is dropped, replace it.
Connect the brake tube clamp to the bracket.
Connect the brake actuator connector.
Note:Make sure that the connector is locked securely.
Make sure that the actuator connector can be connected smoothly. Do not allow water, oil or dirt to enter.
-
CONNECT BRAKE LINE
-
Temporarily install each brake line to the correct positions of the actuator assembly with bracket as shown in the illustration.
Tip:*1: to front wheel cylinder RH
*2: to front wheel cylinder LH
*3: to rear wheel cylinder RH
*4: to rear wheel cylinder LH
*5: from front master cylinder
*6: from rear master cylinder
Using a union nut wrench, tighten each brake line.
15.2 N*m
155 kgf*cm
11 ft.*lbf
Note:Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click hereClick hereClick here).
-
BLEED BRAKE SYSTEM
BLEED CLUTCH LINE (for Manual Transaxle)
for 1AD-FTV:
for 2AD-FTV:
for 2AR-FE:
for 3ZR-FE:
for 3ZR-FAE:
INSTALL AIR CLEANER CASE SUB-ASSEMBLY
for 2AR-FE:
for 3ZR-FE:
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Note:When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereClick hereClick hereClick here).
INSPECT BRAKE ACTUATOR WITH GTS