PROCEDURE
PRECAUTION
Note
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.
REMOVE NO. 1 ENGINE COVER
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
REMOVE AIR CLEANER CAP SUB-ASSEMBLY
REMOVE AIR CLEANER CASE SUB-ASSEMBLY
SEPARATE NO. 1 AIR CLEANER INLET
Remove the bolt and separate the No. 1 air cleaner inlet.
REMOVE ECM
Raise the 2 levers while pushing the locks on the levers, and disconnect the 2 connectors from the ECM.
Note
After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.
Remove the 2 bolts and clamp from the ECM.
REMOVE NO. 1 ECM BRACKET
Remove the 2 screws and No. 1 ECM bracket.
REMOVE NO. 2 ECM BRACKET
Remove the 2 screws and No. 2 ECM bracket.