REAR DOOR BELT MOULDING(for Hatchback, Wagon) REMOVAL

CAUTION / NOTICE / HINT

Tip:
  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE

  1. PRECAUTION (w/ Power Window)

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click hereClick hereClick hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Power Window)

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick hereClick hereClick here

  3. REMOVE REAR ARMREST ASSEMBLY (w/o Power Window)

  4. REMOVE REAR ARMREST ASSEMBLY (w/ Power Window)

  5. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

  6. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)

  7. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

  8. REMOVE REAR DOOR SERVICE HOLE COVER

  9. DISCONNECT REAR DOOR WEATHERSTRIP

    1. B330378

      Disengage the clip and disconnect the rear door weatherstrip.

  10. DISCONNECT REAR DOOR GLASS RUN

  11. REMOVE REAR DOOR REAR WINDOW GUIDE WITH REAR DOOR REAR GUIDE SEAL

  12. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

  13. REMOVE REAR DOOR GLASS RUN

  14. REMOVE REAR DOOR BELT MOULDING ASSEMBLY

    1. Resin Type:

      1. B329290C04

        *a

        Protective Tape

        V100155

        Protective Tape

        Put protective tape around the rear door belt moulding assembly.

      2. Using a screwdriver with its tip wrapped with protective tape, disengage the 6 claws and remove the rear door belt moulding assembly as shown in the illustration.

        Tip:

        Tape the screwdriver tip before use.

    2. Plating Type:

      1. B334551C04

        *a

        Protective Tape

        V100155

        Protective Tape

        Put protective tape around the rear door belt moulding assembly.

      2. Using a screwdriver with its tip wrapped with protective tape, disengage the 5 claws and remove the rear door belt moulding assembly as shown in the illustration.

        Tip:

        Tape the screwdriver tip before use.