Tech Tips
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
Detach the 2 clips and 5 claws.
Disconnect the connector and remove the rear power window regulator switch assembly with rear door armrest base panel.
REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH
Detach the 3 claws and remove the rear door inside handle bezel plug.
REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
Remove the 3 screws.
Detach the 8 clips.
Detach the reference boss in the direction indicated by the arrow in the illustration.
Using a screwdriver, detach the 3 claws and remove the rear door trim board.
Tech Tips
Tape the screwdriver tip before use.
*1 | Reference Boss |
*2 | Protective Tape |
Disconnect each connector.
Disconnect the rear door lock remote control cable and rear door inside locking cable.
REMOVE NO. 2 COURTESY LIGHT ASSEMBLY
Detach the claw and remove the No. 2 courtesy light assembly.
Disconnect the connector.
REMOVE NO. 2 COURTESY LIGHT BULB
Detach the 2 claws and remove the cover.
Remove the No. 2 courtesy light bulb from the No. 2 courtesy light assembly.