PRECAUTION
Note
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.
REMOVE REAR NO. 2 FLOOR BOARD
Remove the rear No. 2 floor board.
REMOVE REAR DECK FLOOR BOX
Remove the rear deck floor box.
REMOVE REAR NO. 3 FLOOR BOARD
Remove the rear No. 3 floor board.
REMOVE DECK FLOOR BOX RH
Remove the clip.
Disengage the 6 guides and remove the deck floor box RH.
REMOVE REAR FLOOR BOARD UPPER NO. 3 PLATE
Disengage the 4 claws and 2 guides, and remove the rear floor board upper No. 3 plate.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE NO. 1 RELAY BLOCK COVER
Disengage the 3 claws and remove the No. 1 relay block cover as shown in the illustration.
REMOVE NO. 1 INTEGRATION RELAY
Disengage the 2 claws and pull up the No. 1 integration relay as shown in the illustration.
Disconnect the 3 connectors and remove the No. 1 integration relay.