DESCRIPTION
Follow the chart below to perform calibration.
Parts to be Replaced | Necessary Operation |
---|---|
Skid control ECU (Brake actuator assembly) | Engine variant learning |
ENGINE VARIANT LEARNING (Using the Intelligent Tester)
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Switch the skid control ECU to Test Mode using the intelligent tester. Enter the following menus: Chassis / ABS/VSC/TRC / Utility / Test Mode.
Tech Tips
Engine variant learning is automatically performed immediately after test mode is entered.
If the engine variant learning has not been done yet, the ABS warning light and slip indicator light begin blinking in the test mode blinking pattern, and then the ABS warning light and brake warning light turn on for approximately 3 seconds.
When the engine variant learning is correctly completed, the ABS warning light and slip indicator light resume blinking in the test mode blinking pattern.
ENGINE VARIANT LEARNING (Using SST Check Wire)
Turn the ignition switch off.
*1 | Front view of DLC3 |
Using SST, connect terminals 12 (TS) and 4 (CG) of the DLC3.
Turn the ignition switch to ON.
Tech Tips
Engine variant learning is automatically performed immediately after test mode is entered.
If the engine variant learning has not been done yet, the ABS warning light, brake warning light and slip indicator light turn on for approximately 5 seconds.
When the engine variant learning is correctly completed, the ABS warning light and slip indicator light begin blinking in the test mode blinking pattern.