PRECAUTION (w/ Navigation System for HDD)
Note
After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.
A hard disk drive (HDD) is built into the navigation receiver assembly to store map data etc. which will be used for the navigation system. Therefore, make sure to read all of the precautions thoroughly before handling the navigation receiver assembly.
EJECT MAP DISC (w/ Navigation System for DVD)
for LHD:
Turn the power switch to ACC.
Push the "INFO" button.
Touch "Map Data" on the navigation screen.
Touch "EJECT DVD" on the navigation screen to eject the map disc.
Turn the power switch off.
for RHD:
Turn the power switch to ACC.
Push the "OPEN" button.
Push the "MAP" button to eject the map disc.
REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY
*a | Lift slightly |
Using a moulding remover, slightly lift the panel at the position shown in the illustration.
Pull the integration control and panel assembly in the direction indicated by the arrow to disengage the 6 claws.
Disconnect each connector and remove the integration control and panel assembly.
REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Pull the lower center instrument cluster finish panel sub-assembly in the direction indicated by the arrow to disengage the 2 claws and 2 clips.
Pull the lower center instrument cluster finish panel sub-assembly in the direction indicated by the arrow to disengage the 5 claws and remove the lower center instrument cluster finish panel sub-assembly.
REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH
Disengage the 14 claws.
Disconnect the connector and remove the instrument cluster finish panel garnish.
REMOVE UPPER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
Disengage the 3 claws.
Disconnect the connector and remove the upper instrument panel finish panel sub-assembly.
REMOVE NAVIGATION RECEIVER WITH BRACKET
Remove the 4 bolts.
Disengage the 4 claws and remove the navigation receiver assembly with bracket as shown in the illustration.
Disconnect each connector.
REMOVE NO. 2 RADIO BRACKET
Remove the 4 screws and No. 2 radio bracket.
REMOVE NO. 1 RADIO BRACKET
Tech Tips
Use the same procedure for the No. 2 radio bracket.
REMOVE NAVIGATION RECEIVER ASSEMBLY