REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY
*a | Lift slightly |
Using a moulding remover, slightly lift the panel at the position shown in the illustration.
Pull the integration control and panel assembly in the direction indicated by the arrow to disengage the 6 claws.
Disconnect each connector and remove the integration control and panel assembly.
REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Pull the lower center instrument cluster finish panel sub-assembly in the direction indicated by the arrow to disengage the 2 claws and 2 clips.
Pull the lower center instrument cluster finish panel sub-assembly in the direction indicated by the arrow to disengage the 5 claws and remove the lower center instrument cluster finish panel sub-assembly.
REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH
Disengage the 14 claws.
Disconnect the connector and remove the instrument cluster finish panel garnish.
REMOVE UPPER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
Disengage the 3 claws.
Disconnect the connector and remove the upper instrument panel finish panel sub-assembly.
REMOVE REAR CONSOLE BOX POCKET
Remove the rear console box pocket.
REMOVE UPPER CONSOLE PANEL
Using a moulding remover, disengage the 3 claws to remove the upper console panel as shown in the illustration.
REMOVE CONSOLE BOX CARPET
Remove the console box carpet.
REMOVE REAR CONSOLE BOX ASSEMBLY
Remove the 5 bolts.
Pull the rear console box assembly in the direction indicated by the arrow to disengage the 8 claws.
Disconnect the connector and remove the rear console box assembly.
REMOVE ELECTRICAL KEY OSCILLATOR
Disconnect the connector.
Disengage the clamp and remove the electrical key oscillator.
Note
Be careful when removing the electrical key oscillator. If the oscillator is dropped, replace it with a new one.
REMOVE NO. 2 CONSOLE BOX MOUNTING BRACKET
Remove the 6 bolts <B> and No. 2 console box mounting bracket.
REMOVE FRONT NO. 1 CONSOLE BOX INSERT
Pull the front No. 1 console box insert in the direction indicated by the arrow to disengage the 4 claws and guide, and remove the front No. 1 console box insert.
REMOVE FRONT NO. 2 CONSOLE BOX INSERT
Pull the front No. 2 console box insert in the direction indicated by the arrow to disengage the 4 claws and guide, and remove the front No. 2 console box insert.
REMOVE BOX BOTTOM MAT
Disengage the fastener and remove the box bottom mat.
SEPARATE CONSOLE BOX ASSEMBLY
Remove the bolt <B> and 2 clips.
While pushing the parts shown in the illustration inward, pull the console box assembly in the direction indicated by the arrow to disengage the 2 claws and 4 guides.
Disconnect the connector and separate the console box assembly.
REMOVE AIR CONDITIONING CONTROL ASSEMBLY
Disengage the 4 claws and remove the air conditioning control assembly as shown in the illustration.
Disconnect the connector.
Note
Since the connectors for the air conditioning control assembly and the integration control and panel sub-assembly are the same shape, mark them so that they will not be reconnected incorrectly.
REMOVE SHIFT LOCK CONTROL UNIT ASSEMBLY
Disconnect the connector from the shift lock control unit assembly.
Remove the 3 nuts and shift lock control unit assembly.
REMOVE UPPER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
Disengage the clamp.
Remove the 2 bolts <A>.
Pull the upper instrument panel finish panel assembly in the direction indicated by the arrow to disengage the 9 claws and remove the upper instrument panel finish panel assembly.
REMOVE NO. 1 SWITCH HOLE BASE
Disengage the 5 claws.
Disconnect the connector to remove the No. 1 switch hole base.
REMOVE ROOM TEMPERATURE SENSOR
Disengage the 2 claws and remove the room temperature sensor from the No. 1 switch hole base.