PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (Click here).
REMOVE BATTERY SERVICE HOLE COVER
Remove the clip and battery service hole cover.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
REMOVE INSTRUMENT PANEL FINISH PANEL END LH
for Automatic Air Conditioning System:
Put protective tape around the instrument panel finish panel end.
*1 | Protective Tape |
Using a moulding remover, detach the 3 clips and 2 guides, and remove the instrument panel finish panel end.
for Manual Air Conditioning System:
Put protective tape around the instrument panel finish panel end.
*1 | Protective Tape |
Using a moulding remover, detach the 3 clips and guide, and remove the instrument panel finish panel end.
REMOVE INSTRUMENT PANEL FINISH PANEL END RH
for Automatic Air Conditioning System:
Put protective tape around the instrument panel finish panel end.
*1 | Protective Tape |
Using a moulding remover, detach the 3 clips, claw and 2 guides, and remove the instrument panel finish panel end.
for Manual Air Conditioning System:
Put protective tape around the instrument panel finish panel end.
*1 | Protective Tape |
Using a moulding remover, detach the 3 clips, claw and guide, and remove the instrument panel finish panel end.
REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY
Detach the 8 claws and 4 guides.
Disconnect the connector and remove the center instrument panel register.
REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type)
Remove the 4 screws.
Pull the radio receiver to detach the 4 clips on the backside of the radio receiver with bracket.
Disconnect the connectors and remove the radio receiver with bracket.
REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (for Radio and Display Type)
Detach the 4 clips, 3 claws and 3 guides, and remove the center instrument cluster finish panel.
REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display Type)
Remove the 4 screws.
Pull out the radio and display receiver assembly with bracket.
Disconnect the connectors and remove the radio radio and display receiver assembly with bracket.
REMOVE NO. 1 RADIO BRACKET (for Radio Receiver Type)
Remove the 3 screws and No. 1 radio bracket.
REMOVE NO. 1 RADIO BRACKET (for Radio and Display Type)
Remove the 3 screws and No. 1 radio bracket.
REMOVE NO. 2 RADIO BRACKET (for Radio Receiver Type)
Remove the 3 screws and No. 2 radio bracket.
REMOVE NO. 2 RADIO BRACKET (for Radio and Display Type)
Remove the 3 screws and No. 2 radio bracket.