REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Seat Type 60 Side) INSTALLATION

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. INSTALL REAR SEAT CUSHION LOCK STRIKER SUB-ASSEMBLY


    1. Install the 4 lock strikers with the 10 bolts.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }
      A0155AZE01
  2. INSTALL REAR NO. 6 AIR DUCT (w/ Rear Air Conditioning System)


    1. Install the duct with the 5 screws.

    2. Connect the 2 connectors.

      A0158L2
  3. INSTALL FRONT FLOOR CARPET ASSEMBLY


    1. Install the floor carpet.

  4. INSTALL REAR AIR DUCT GUIDE (w/ Rear Air Conditioning System)


    1. A015AAR

      Attach the claw to install the guide.

    2. Install the screw.

      Tech Tips

      Use the same procedures for both sides.

  5. INSTALL AIR DUCT PLUG (w/ Rear Air Conditioning System)


    1. A015CYQ

      Attach the 2 claws to install the plug.

      Tech Tips

      Use the same procedures for both sides.

  6. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH


    1. w/ Sliding Roof:

      Install the front quarter trim panel assembly LH Click here.

    2. w/o Sliding Roof:

      Install the front quarter trim panel assembly LH Click here.

  7. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY RH


    1. w/ Sliding Roof:

      Install the front quarter trim panel assembly RH Click here.

    2. w/o Sliding Roof:

      Install the front quarter trim panel assembly RH Click here.

  8. INSTALL REAR SEAT COVER CAP (w/ Rear No. 2 Seat, except Face to Face Seat Type)

    A015E2E

    Tech Tips

    Use the same procedure to install the rear seat cover cap on the other side.


    1. Attach the 3 claws to install the rear seat cover cap.

  9. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE

    A015BES

    1. Attach the 6 clips to install the support plate.

  10. INSTALL REAR NO. 2 SEAT ASSEMBLY


    1. for Face to Face Seat Type:

      Install the rear No. 2 seat assembly Click here.

    2. except Face to Face Seat Type:

      Install the rear No. 2 seat assembly Click here.

  11. INSTALL REAR DOOR SCUFF PLATE LH

    A015BJQ

    1. Attach the 3 claws and 4 clips to install the scuff plate.

    2. Install the screw.

  12. INSTALL REAR DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedures described for the LH side.

  13. INSTALL REAR STEP COVER

    A0159DZ

    Tech Tips

    Use the same procedure to install the step cover on the other side.


    1. Attach the 2 claws to install the step cover.

  14. INSTALL REAR NO. 2 SEAT PROTECTOR

    A015DUXE01

    1. Attach the 10 claws to install the 2 seat protectors.

  15. INSTALL REAR NO. 1 SEAT PROTECTOR

    A0159Q9E01

    1. Attach the 10 claws to install the 2 seat protectors.

  16. INSTALL REAR NO. 1 SEAT ASSEMBLY RH


    1. Install the rear No. 1 seat assembly RH Click here.

  17. INSTALL REAR NO. 1 SEAT ASSEMBLY LH

    A015AY4E01

    1. Temporarily install the seat assembly with the 4 bolts.

      Note

      Be careful not to damage the vehicle body.

    2. Tighten the bolts in the order shown in the illustration.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }
    3. A01568C

      w/ Rear Seat Side Airbag:

      Connect the connector.

    4. w/ Seat Heater System:

      Connect the connector.

  18. INSTALL REAR NO. 4 SEAT CUSHION HINGE COVER

    A0158IT

    1. Attach the 2 clips and 2 claws to install the cover.

  19. INSTALL REAR NO. 2 SEAT CUSHION HINGE COVER

    A0159VV

    1. Attach the 2 clips and 2 claws to install the cover.

  20. INSTALL REAR NO. 5 SEAT CUSHION HINGE COVER


    1. Return the seat to the upright position.

    2. A015BB1

      Attach the 7 claws to install the cover.

  21. INSTALL REAR NO. 3 SEAT CUSHION HINGE COVER

    A0157WA

    1. Attach the 6 claws to install the cover.

  22. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  23. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.

  24. INSPECT REAR NO. 1 SEAT ASSEMBLY LH


    1. w/ Seat Heater System:

      Check the seat heater operation.


      1. Turn the ignition switch to ON.

      2. Turn the seat heater switch on.

      3. Wait 5 minutes or more and confirm that the seat surface becomes warm.