DESCRIPTION
Refer to DTCs C1419 and C1435 Click here.
DTC Code | DTC Detection Condition | Trouble Area |
---|---|---|
C1420 | After the difference between GL1 and GL2 becomes 0.6 G or more with the vehicle stationary, the difference remains 0.4 G or more for 60 seconds or more. |
|
INSPECTION PROCEDURE
Note
When replacing the yaw rate sensor, perform zero point calibration Click here.
Tech Tips
When DTC U0123 and/or U0124 and/or is output together with DTC C1420, inspect and repair the trouble areas indicated by DTC U0123 and/or U0124 first Click here.
PROCEDURE
CHECK YAW RATE SENSOR INSTALLATION
Check that the yaw rate sensor has been installed properly Click here.
OK |
---|
The sensor is tightened to the specified torque. |
The sensor is not installed in a tilted position. |
Tech Tips
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step Click here.
NG |
INSTALL YAW RATE SENSOR CORRECTLY Click here |
OK |
REPLACE YAW RATE SENSOR Click here