Tech Tips
Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
If the sensor rotor needs to be replaced, replace the front drive outboard joint shaft assembly.
PRECAUTION
Note
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work Click here.
DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL
REMOVE FRONT FENDER LINER
Tech Tips
Use the same procedure for the LH side and RH side Click here.
REMOVE FRONT SPEED SENSOR
Disconnect the connector and disengage the clamp.
Remove the bolt and front speed sensor clamp from the body.
Remove the bolt, front flexible hose and front speed sensor clamp together from the shock absorber assembly.
*1 | Front Speed Sensor Clamp |
*2 | Front Flexible Hose |
Disengage the clamp from the front shock absorber assembly.
Remove the bolt and front speed sensor from the steering knuckle.
Note
Prevent foreign matter from attaching to the front speed sensor tip.
Clean the speed sensor installation hole and the contact surfaces every time the front speed sensor is removed.