PRECAUTION
Note
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable some systems need to be initialized after the cable is reconnected Click here.
DISCONNECT CONNECTOR HOLDER BLOCK
Remove the 3 bolts and move the connector holder block so that the ECM can be removed in the next step.
REMOVE ECM
Raise the 2 levers while pushing the locks on the 2 levers.
Note
Make sure that the lock levers are raised 90° as shown in the illustration before disconnecting the ECM connectors. Failure to do this may cause the ECM connectors to break.
Disconnect the 2 connectors.
Remove the 4 bolts and ECM.
REMOVE GASKET
Peel off the gasket.
Spray gasket remover or equivalent on the remaining tape of the gasket.
Note
When using gasket remover or equivalent, cover the ECM connector with a cloth.
Remove the tape of the gasket without using bladed objects.