DESCRIPTION
The turn signal flasher receives a hazard warning signal switch information signal, and illuminates the turn signal lights.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY
*1 | Component without harness connected (Hazard Warning Signal Switch Assembly) |
Remove the hazard warning signal switch Click here.
Measure the resistance according to the value(s) in the table below.
Standard Resistance | ||||||||
---|---|---|---|---|---|---|---|---|
|
NG |
REPLACE HAZARD WARNING SIGNAL SWITCH ASSEMBLY Click here |
OK |
CHECK HARNESS AND CONNECTOR (HAZARD WARNING SIGNAL SWITCH - TURN SIGNAL FLASHER AND BODY GROUND)
*1 | Component without harness connected (Main Body ECU [for LHD]) |
*2 | Component without harness connected (Center Airbag Sensor) |
*3 | Front view of wire harness connector (to Turn Signal Flasher Assembly [for RHD]) |
*4 | Front view of wire harness connector (to Hazard Warning Signal Switch Assembly) |
Disconnect the D61 hazard warning signal switch connector.
for LHD:
Remove the turn signal flasher.
for RHD:
Disconnect the D106 turn signal flasher connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance | ||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|
for LHD | ||||||||||||
|
||||||||||||
for RHD | ||||||||||||
|
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
OK |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here