REMOVE INSTRUMENT PANEL FINISH PANEL END LH
*1 | Protective Tape |
Apply protective tape to the area shown in the illustration.
Insert a roof moulding remover and slide the remover toward the clip.
Pull the remover with both hands to disengage the clip as shown in the illustration.
Disengage the 3 clips and remove the instrument panel finish panel end LH.
REMOVE INSTRUMENT PANEL FINISH PANEL END RH
*1 | Protective Tape |
Apply protective tape to the area shown in the illustration.
Insert a roof moulding remover and slide the remover toward the clip.
Pull the remover with both hands to disengage the clip as shown in the illustration.
Disengage the 3 clips and remove the instrument panel finish panel end RH.
REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY
Disengage the 5 claws, 2 clips, and 3 guides.
Disconnect the connector and remove the center instrument panel register assembly.
REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Disengage the 4 clips and remove the center instrument cluster finish panel sub-assembly.
REMOVE RADIO AND DISPLAY RECEIVER WITH BRACKET
Remove the 4 bolts.
Disconnect each connector and remove the radio and display receiver with bracket.
REMOVE NO. 2 RADIO BRACKET
w/o Navigation System:
Remove the 3 screws and No. 2 radio bracket.
w/ Navigation System:
Remove the 5 screws and No. 2 radio bracket.
REMOVE NO. 1 RADIO BRACKET
w/o Navigation System:
Remove the 3 screws and No. 1 radio bracket.
w/ Navigation System:
Remove the 5 screws and No. 1 radio bracket.
REMOVE EXTENSION MODULE
Disconnect each connector and remove the navigation wire and radio cable.
Disconnect the connector to remove the extension module.