CHECK INJECTOR COMPENSATION CODE
Note
When the ECM is replaced, all of the existing injector compensation codes must be input into the new ECM and the learning value of the fuel supply pump assembly must be initialized.
Check that the injection compensation codes of the fuel injectors installed on the cylinders match the ones registered in the ECM.
w/ DPF: Click here
w/o DPF: Click here
If they do not match, correct the registered data.
w/ DPF: Click here
w/o DPF: Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE FRONT DOOR SCUFF PLATE RH
Tech Tips
Use the same procedure as for the LH side.
REMOVE FRONT SEAT ASSEMBLY RH
for Hi-back Seat Type Click here
for Low-back Seat Type Click here
for Split Bench Seat Type Click here
REMOVE ECM
Fold back the floor carpet.
Disconnect the 6 ECM connectors.
Detach the 2 clips and remove the ECM together with the wire harness support.
Remove the 4 bolts and wire harness support.
REMOVE NO. 3 ECM BRACKET
Remove the 4 screws and 2 No. 3 ECM brackets.
REMOVE NO. 2 ECM BRACKET
Remove the 2 screws and No. 2 ECM bracket.
REMOVE NO. 1 ECM BRACKET
Remove the 2 screws and No. 1 ECM bracket.