PRECAUTION
Note
After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE ECM COVER
Remove the 3 bolts and ECM cover.
Note
Remove all water on and around the ECM cover.
Perform the inspection indoors to avoid rain.
Be sure to prevent water intrusion to the ECM (connectors and screw parts).
REMOVE TCM
Disconnect the 2 engine wire connectors from the connector holder.
Disengage the claw and disconnect the junction connector from the connector holder.
*1 | Grommet |
Using a screwdriver, disengage the claw.
Disconnect the grommet and connector holder from the engine room ECM box.
Disconnect the 2 ECM connectors.
Disconnect the 2 TCM connectors.
Remove the 2 nuts and TCM from the engine room ECM box.
Note
If a TCM has been struck or dropped, replace it.
Remove the 4 screws and 2 brackets from the TCM.